SNMP
Configuring SNMP Notification Recipients
Cisco 220 Series Smart Switches Administration Guide Release 1.1.0.x 284
19
• Configuring SNMPv1,2 Notification Recipients
• Configuring SNMPv3 Notification Recipients
Configuring SNMPv1,2 Notification Recipients
To define a recipient in SNMPv1,2:
STEP 1 Click SNMP > Notification Recipients SNMPv1,2.
STEP 2 To create an SNMPv1,2 notification recipient, click Add.
STEP 3 Enter the following information:
• Server Definition—Select whether to define the notification recipient by IP
address or name.
• IP Version—Select either Version 4 or Version 6 if the notification recipient
is identified by IP address.
• Recipient IP Address/Name—Enter the IP address or hostname of the
recipient that the traps are sent.
• UDP Port—Enter the UDP port used for notifications on the recipient device.
• Notification Type—Select whether to send Traps or Informs. If both are
required, two recipients must be created.
• Timeout—Enter the number of seconds that the switch waits before re-
sending informs. The default is 15 seconds.
• Retries—Enter the number of times that the switch resends an inform
request. The default is 3.
• Community String—Select the SNMP community for the trap manager.
• Notification Version—Select the trap SNMP version. Either SNMPv1 or
SNMPv2 may be used, with only a single version enabled at a single time.
STEP 4 Click Apply. The SNMPv1,2 notification recipient is defined, and the Running
Configuration is updated.
To Next Page
Loading...
Need help?
General
