Port Management
Configuring Energy Efficient Ethernet
Cisco 220 Series Smart Switches Administration Guide Release 1.1.0.x 121
9
• Interface—Select the port to be defined.
• LACP Port Priority—Enter the LACP priority value for the selected port.
• LACP Timeout—Select long or short timeout for neighbor LACP PDUs,
which will affect the periodic transmissions of neighbor LACP PDUs at either
a slow (Long) or fast (Short) transmission rate.
STEP 6 Click Apply. The Running Configuration is updated.
Configuring Energy Efficient Ethernet
Energy Efficient Ethernet (EEE) is designed to save power when there is no traffic
on the link. With Energy Efficient Ethernet, power is reduced when the port is up,
but there is no traffic on it.
Energy Efficient Ethernet reduces overall power usage in Energy-Detect mode.
Energy Efficient Ethernet is defined per port, regardless of their LAG membership.
To enable Energy Efficient Ethernet on a port:
STEP 1 Click Port Management > Energy Efficient Ethernet > Port Settings.
STEP 2 Select a port and click Edit.
• Interface—Select the port to be configured.
• Energy Efficient Ethernet—Check Enable to enable Energy Efficient
Ethernet on the port, or uncheck to disable it on the port.
STEP 3 Click Apply. The Energy Efficient Ethernet is enabled or disabled on the port, and
the Running Configuration is updated.
To Next Page
Loading...
Need help?
General
