EasyManuals Logo

Cisco SG220-26P Administration Guide

Cisco SG220-26P
289 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #108 background imageLoading...
Page #108 background image
9
Cisco 220 Series Smart Switches Administration Guide Release 1.1.0.x 106
Port Management
This chapter describes port configuration, link aggregation, and the Energy
Efficient Ethernet feature.
It includes the following topics:
Port Management Workflow
Configuring Basic Port Settings
Configuring Error Recovery Settings
Loopback Detection
Configuring Link Aggregation
Configuring Energy Efficient Ethernet
Port Management Workflow
To configure ports, perform the following actions:
STEP 1 Configure basic port parameters on the Port Settings page, as described in the
Configuring Basic Port Settings section.
STEP 2 Enable or disable the error-disabled ports to recover from specific causes and
manually activate the suspended ports on the Error Recovery Settings page, as
described in the Configuring Error Recovery Settings section.
STEP 3 Enable or disable the Link Aggregation Control (LAG) protocol, and configure the
potential member ports to the desired LAGs on the LAG Management page, as
described in the Configuring Link Aggregation section. By default, all LAGs are
empty.
STEP 4 Configure the Ethernet parameters, such as speed and auto-negotiation for the
LAGs on the LAG Settings page, as described in the Configuring LAG Settings
section.

Table of Contents

Other manuals for Cisco SG220-26P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SG220-26P and is the answer not in the manual?

Cisco SG220-26P Specifications

General IconGeneral
ModelSG220-26P
Ports26
PoE Ports24
Switching Capacity52 Gbps
Forwarding Rate38.69 Mpps
LayerLayer 2
Power SupplyInternal
VLANs Supported256
ManagementWeb-based GUI, SNMP
Operating Temperature0°C to 40°C
Storage Temperature-4°F to 158°F (-20°C to 70°C)
Operating Humidity10% to 90% non-condensing
Storage Humidity5% to 95% non-condensing
Dimensions440 x 44 x 257 mm
Weight3.3 kg

Related product manuals