Cisco UCS X210c M6 User Manual

CHAPTER 2
Installing a Compute Node
This chapter contains the following topics:
• Removing a Compute Node Blank, on page 9
• Installing a Compute Node Blank, on page 10
• Removing a Compute Node, on page 12
• Installing a Compute Node, on page 13
• Compute Node Configuration, on page 14
Removing a Compute Node Blank
Do not operate the Cisco UCS X9508 chassis with an empty compute node slot. Fill any empty compute node
slots with either a blank or a compute node.
Use this task to remove a compute node blank.
Step 1 Grasp the compute node blank by the finger holds.
Step 2 Pull the blank towards you until it is completely removed from the chassis.
Notice that the module blank has indicators that show how to orient the blank. You will use this information when you
install a blank.
Cisco UCS X210c M6 Compute Node Installation and Service Note
9

Cisco UCS X210c M6 Specifications

General

Brand	Cisco
Model	UCS X210c M6
Category	Server
Language	English