Step 1 Align the front mezzanine module with its slot on the compute node.
Step 2 Lower the front mezzanine module onto the compute node, making sure that the screws and screwholes line up.
Step 3 Secure the front mezzanine module to the compute node.
a) Using a #2 Phillips screwdriver, tighten the captive screws on the top of the front mezzanine module.
This step may be skipped if installing the front mezzanine blank (UCSX-X10C-FMBK).
Note
Cisco UCS X210c M6 Compute Node Installation and Service Note
26
Servicing a Compute Node
Installing the Front Mezzanine Module
To Next Page
Loading...
