Step 1 Insert the Super Cap module into its case.
a) Align the SuperCap module so that the connector will meet the connector.
b) Before seating the SuperCap module, make sure that the ribbon cable is not in the way. You do not want to pinch the
ribbon cable when you install the SuperCap.
c) When the ribbon cables are clear of the case, press the SuperCap module until it is seated in the case.
You might feel some resistance as the SuperCap snaps into place.
Cisco UCS X210c M6 Compute Node Installation and Service Note
33
Servicing a Compute Node
Installing the SuperCap Module
To Next Page
Loading...
