84
——
10.1 Plastic Surface of Printer and Platen
Use a soft cloth or cotton swab dipped with a small amount of ethyl alcohol to wipe off
dust and dirt.
CAUTION
Using an excessive amount of ethyl alcohol to clean the platen may cause surface deformation,
which would result in unstable feed operation.
10.2 Thermal head
Use a cotton swab dipped with a small amount of ethyl alcohol.
CAUTION
The thermal head is hot immediately after printing. Do not touch the thermal head at this time.
Do not touch the thermal head with bare hands or do not allow metals to come into contact
with the thermal head.
To Next Page
Loading...
