- 23 -
8.1. Automatic balance calibration
It is performed w
hen:
- Period of time passes from last calibration
- temperature changes for settled value by manufacturer
* for balances CX is 0,8° C,
Following information appears on the display:
Draw. 11. Automatic calibration – display view
Time delay in starting the calibration up enables user to take load off the pan untill the
measurements are performed. If the T/O key is pressed the calibration process is stopped.
Set up automatic calibration
Draw. 12. Set up automatic balance calibration
1 – main menu number
2 – function selection factor
3 – function name
4 – name of actual activity
5 – selects factor to autocalibration (time / temp.)
6 – declaring autocalibration time
7 – value of factors for autocalibration
8 – value of time for autocalibration
If the value for autocalibration factor and time changes descriptions for these lines changes
as well (on the drawing field No9. And No 10.)
To Next Page
Loading...
