Citizen CX 165 - Access to Mass Units; Setting Accessibility of the Work Modes

- 34 -
14. ACCESS TO MASS UNITS
In this group
of parameters user declares mass units which are accessible for operator
directly under the key Units.
All units which value of the parameters is set up at 1: yes are accessible from the level of
switching between units.
For units described as 09 Taele Hk., 10 Taele S., 11 Taele T . there are following
dependences:
• If all of them have attribute 1: yes the balance show only first of them 09 Taele
Hk
If the measurement is done in units 11 Taele T set the attribute 0 : no for two previous
Enter group of the parameters P7 Units according to p. 5.2.7.
Draw. 24. Measure units – setting
After set proper values of the parameters return to weighing mode in accordance to p 6.1.2
of the manual.
For verified balances following measure units are available:[g], [mg], [ct] –despite setting 1
– YES in balance menu .
15. SETTING ACCESSIBILITY OF THE WORK MODES
In this group
of parameters user declares work modes which are accessible for operator
after pressing Mode key.