- 35 -
Draw. 25. The balance functions -setting
All work modes values of the parameters are 1: yes are accessible from the level of
switching between work modes. The changes of the parameters can be done according to
p. 6.1.1 of the manual.
16. OTHER PARAMETERS
User can set p
arameters have influence on work with balance in group of the parameters
P9 Others eg. beep signals etc. Enter submenu group P9 Others the same as in p. 14.
01 Setting ID
it includes 6 digits 6 codes which can be used during printouts for product
specification, operator, batch etc.
02 Automatic printout ID
for the option YES all digit codes are printed, for option NO the codes are not printed.
03 Signal
Beep signal for pressing keys
04 Language
Selection of languages
05 Backlight
switch on/off the backlight
To Next Page
Loading...
