- 32 -
11.1. Setting filter
Dep
endly on conditions set the filter. If the conditions are conductive set the filter as very
fast (value of the parameter 01 Filter 1) and if the conditions are bad (vibrations, draught)
set the filter as slowly or very slowly (value of the parameter 01 Filter at 4 or 5). Efficience
of filter is different for range of weighing. The filter works slower during getting to weighed
mass. It works faster when mass is the settled filer range (parameter filter range accessed
only from service menu – user does not have access).
11.2. Value release
Select an
d set way for stability result of weighing: fast, fast +reliable or reliable.
Dependly on selected option time of weighing is sorter or longer.
11.3. Set the display refreshing time
This parameter determines period of time which the display refreshes in.
For higher values of the refreshing parameter indirect not stable mass indications are not
presented on the display during putting on and taking off the load.
For low values all changes in mass during weighing are visible – it enables to dosage
liquids and solids. The refreshing time is settled in seconds.
11.4. Set autozero working
T
o ensure precise indications programmable function „AUTOZERO” is in the balance. This
function controls automatically and corrects zero indication of the balance.
If the AUTOZERO function is active each measurement starts at precise zero every time.
In special cases this function disturbes in the measurements eg. when the load is put on
the pan very slowly (pouring substance)
In this case correcting system of zero indication can correct also indication of real load
mass. AUTOZERA is switched on and off in the parameter P4 03 in accordance with p.
6.1.1 of the manual.
11.5. Last digit
T
o ensure comfort of work with the balance user determines (dependly on needs) if last
digit should be displayed and when. One of the following values can be selected:
- 0 never
- 1 always
- 2 when stab
To Next Page
Loading...
