Why is my Citizen SA-SD measurement remaining unchanged?
Check if a hold signal is being input. If so, "HOLD" is displayed in the lower right corner of the display. Turn the power OFF, and then disconnect and reconnect the detector.
What to do if Citizen SA-SD Controller displays error E100?
Error E100 means that both NPN and PNP output types are connected. Connect only the same output type.
What does Citizen SA-SD Controller error E110 mean?
Error E110 indicates that too many units are connected. Up to 15 slave units can be connected to one master unit.
What to do if Citizen SA-SD displays error E140?
Error E140 means the calculation function is set to ON with no slave units connected. Set the calculation mode to OFF.
What does Citizen SA-SD error E150 indicate?
Error E150 indicates that with the calculation function in effect, not enough slave units are connected. Set the calculation mode to OFF, or change the calculation app selection setting.
Why is Citizen SA-SD showing error E160?
Error E160 means the number of connected units differs from the stored number. Set the Number of connected units check function to OFF.
General| Brand | Citizen |
|---|---|
| Model | SA-SD |
| Category | Controller |
| Language | English |
To Next Page