clare H101 - Page 95

Single Phase Power Measurement
Display Range and Accuracy 0.02kVA-5.00kVA ±2% ±0.02kVA
Selectable Range of Pass/Fail Levels 0.001kVA-5.000kVA
Power Output Rating
Test Voltage 110V – 230V AC 20A nominal (Vin-
Vout)
Maximum Power Output
Up to 5.0kVA (dependant on mains
supply rating)
Single Phase Power Factor Measurement
Display Range and Accuracy Ratio 0.000 -1.000 ± 0.030
Selectable Range of Pass/Fail Levels 0.000-1.000
Leakage Current Measurement
Display Range and Accuracy 0.10mA-20.00 mA ± 1% ±5 Counts
Display Resolution 0.01mA
Selectable Range of Pass/Fail Levels 0.01mA-20mA
Touch Current Measurement
Display Range and Accuracy 0.02mA - 5.00 mA ± 1% ±5 Counts
Display Resolution 0.01
Selectable Range of Pass/Fail Levels 0.02mA-5.00mA
Measuring Device
IEC/EN 60990 Fig 4
(IEC/EN 60990 Fig 3 or Fig 5 Upon Request)
110V – 230V
Vout)
p to 5.0
ply ra
AC 20A nomina
pe
(Vin
st)
990 F
0990 F
ig 4
g 3 or F
-5.0
0mA
Power
Outpu
Selectab
Measuring
e and
esolution
e Range of Pas
Device
urement
curacy 0
s/Fail L
R
Levels
0m
A-
tio 0.000 -1.0
0.00
± 0.030
1000
Disp
Select
g
play Ra
lay Res
Current
nge and
t
Mea
Ac
ail Lev
0.02k
vels
kVA-5.00
0kVA ±
0
%