Clarke CA60 20D - Wheel System Troubleshooting

Service Manual-CA60 14 Wheel System 26
Troubleshooting
Trouble
Possible causes
Remedy
The machine does not move
Thermal fuse blown/broken
Reset/Replace
The machine has been started using the
ignition key, keeping one of the switches
pressed.
Turn the ignition key to “0”, then
restart the machine without pressing
the switches.
Drive is weak or non-existent
Cord entangled in wheel hubs
Remove
The motor is faulty
Check the motor amperage/replace the
motor
Drive system electronic board faulty
Replace