Clear-Com TEMPEST 2400 - Page 24

18 Tempest®2400 2-Channel Wireless Intercom System
6- Local Area Network (LAN) RJ-45 Connector
The Local Area Network (LAN) RJ-45 Connector is used to connect the Tempest BaseStaon to a user supplied PC running
Tempest Desktop Conguraon (T-Desk®) soware. The user can then monitor and/or adjust BaseStaon and BeltStaon
sengs via the PC interface. This connecon can be made directly or through a Local Area Network (LAN). See the separate
T-Desk User Manual for more informaon.
7- Relay Connector
The Relay Connector provides access to all of the relay closure contacts for the Tempest BaseStaon. There are six
relays including one common Stage Announce relay and ve individually assignable relays - one for each of the wireless
BeltStaons. See the secon on “GPO Relay Contacts.
8- Antenna Connector
The Antenna Connector is used to connect the antenna to the Tempest BaseStaon. The Antenna Connector is an RP-TNC
(Reverse Polarized-TNC) connector. Cables used to aach to this Antenna Connector must be properly terminated with
mang RP-TNC connectors and the proper cable type.
9- Remote Transceiver RJ-45 Connector
The Tempest Remote Transceiver RJ-45 connector is used to connect the oponal remote transceiver to the Tempest
BaseStaon. The remote transceiver can be located up to 1,500 feet from the BaseStaon.