Clear-Com TEMPEST 2400 - Page 27

21 Tempest®2400 2-Channel Wireless Intercom System
Talk Buon A and B
There are two TALK buons on each BeltStaon, one for
channel A and the other for channel B. The Talk buon
enables the microphone signal for the assigned intercom
channels.
Tempest uses an intelligent latching method for TALK
buons. Pressing the TALK buon momentarily will cause
the TALK buon to latch. Pressing and holding the TALK
buon will cause the buon to act as a momentary switch.
Talk tones can be enabled or disabled per BeltStaon. If
enabled, users will here a tone each me the TALK buon
is pressed.
Channel Indicator LEDs A and B
Each Talk buon has two individual LED indicators. Together they surround the
Talk buon. The LEDs will ash blue to indicate which intercom channel, A or
B, has been selected and will illuminate connuously to indicate that “Talk” is
enabled on that channel.
The Channel Indicator LEDs will ash red when the microphone signal is reaching
a peak level and is entering into liming.