EasyManua.ls Logo

Clear-Com TEMPEST 2400 - Page 67

Clear-Com TEMPEST 2400
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
61 Tempest®2400 2-Channel Wireless Intercom System
When an external 2-Wire hard wired intercom system IS present:
Set the 2-Wire Intercom Type Select Switch to the proper type and select 2-Wire mode. Connect the hard wired
intercom to the BaseStaon. In this conguraon, each connected Tempest BaseStaon intercom channel will receive
power and terminaon from the wired intercom system. The Tempest BaseStaon funcons as an addional wired
BeltStaon from the perspecve of the connected 2-Wire system.
Connect either male or female (male and female connectors are electrically idencal) 3 pin XLR from the 2-Wire
intercom channel to be shared, to the BaseStaon that will use the intercom channel. Loop to other BaseStaons
as needed. Repeat for all channels to be shared. See the Wired Intercom Interface secon in this manual for more
informaon about connecng to external wired intercom systems.
When using an external 2-Wire hard wired connecon, only channels that are
connected to a wired intercom will be able to share audio between BaseStaons.

Table of Contents

Other manuals for Clear-Com TEMPEST 2400

Related product manuals