ClearView Hawk Series - Preset Setup; Activate Preset; Patrol Setup; Activate Patrol

74
6.2.1 Preset Setup
Note: The following setups are usually operated in the X405H405H 405HFigure 6-2X, X406H406H406 HFigure 6-5X and X407H407H407 HFigure
6-6
X.
In
X408H408H 408HFigure 6-2X, use eight direction arrows to adjust camera to the proper position.
In
X409H409H 409HFigure 6-5X, click preset button and input preset number. The interface is shown as in X410H410H41 0HFigure
6-7
X.
Add this preset to one patrol number
6.2.2 Activate Preset
Figure 6-7
In X411H411H 411HFigure 6-6X please input preset number in the No. blank, and click preset button.
6.2.3 Patrol Setup
In X412H412H 412HFigure 6-5X, click patrol button. The interface is shown as in X413H413H413 HFigure 6-8X.
Input preset number and then add this preset to one patrol.
6.2.4 Activate Patrol
Figure 6-8
In X414H414H 414HFigure 6-6X, input patrol number in the No. blank and click patrol button
6.2.5 Pattern Setup
In X415H415H 415HFigure 6-5X, click pattern button and then click begin button. The interface shows like X416H416H 416HFigure
6-9
X.
Please go to
X417H417H417 HFigure 6-2X to modify zoom, focus, and iris. Go back to X418H418H418H Figure 6-9X and click end
button.
You can memorize all these setups as pattern 1.