COBHAM AVIATOR 700S - Page 8

-vi Chapter : 98-158751-C
4.3 Electrical installation and wiring .........................................................4-6
4.3.1 Wiring symbols .....................................................................................4-6
4.3.2 Wiring – overview .................................................................................4-7
4.3.3 To wire the CSDU with AC input .........................................................4-8
4.3.4 To wire the MCHPA with AC input ...................................................4-10
4.3.5 To wire the SCM .................................................................................4-12
4.3.6 To wire the MCHPA ...........................................................................4-12
4.3.7 To wire the MCDU 1, 2 and 3 .............................................................4-13
4.3.8 To wire the CMU 1 and 2 ...................................................................4-13
4.3.9 To wire aircraft AES ID ......................................................................4-14
4.3.10 To wire cockpit audio 1 and 2 .............................................................4-14
4.3.11 To wire IRS/GNSS ..............................................................................4-15
4.3.12 To wire antenna BITE .........................................................................4-15
4.3.13 To wire EICAS/FWS ..........................................................................4-16
4.3.14 To wire discrete inputs and outputs ....................................................4-16
4.3.15 To wire airborne data loader ...............................................................4-17
4.3.16 To wire Antenna multi control ............................................................4-18
4.3.17 To wire fault/health reporting (CFDS) ................................................4-18
4.3.18 To wire Ethernet 1 (AISD#1 or EFB 1) ..............................................4-18
4.3.19 To wire Ethernet 11 (AISD#2 or EFB2) .............................................4-19
4.3.20 To wire Ethernet 3 (ADL in ACD) .....................................................4-19
4.3.21 To wire Ethernet 2 (PIESD#1 or Cabin1) ...........................................4-20
4.3.22 To wire Ethernet 12 (PIESD#2 or Cabin2) .........................................4-20
4.3.23 To wire Ethernet 4 (ACD#1) ...............................................................4-21
4.3.24 To wire Ethernet 5 (ACD#2) ...............................................................4-21
4.3.25 To wire the Maintenance interfaces ....................................................4-22
4.3.26 CSDU ARINC 600 connector block ...................................................4-25
4.3.27 MCHPA ARINC 600 connector block ...............................................4-33
4.4 Recommended cables ..........................................................................4-37
4.4.1 Introduction .........................................................................................4-37
4.4.2 Allowed cable lengths for power cables .............................................4-37
4.4.3 Recommended power cables ...............................................................4-38
4.4.4 Recommended RF cables ....................................................................4-38
4.4.5 Recommended cables for ARINC 429 ................................................4-38
4.4.6 Recommended cables for Ethernet ......................................................4-38
4.4.7 Recommended cables for discrete signals ...........................................4-39
4.4.8 Recommended cable between the SCM and the CSDU .....................4-39
4.5 Verifying the installation ....................................................................4-39
4.6 Activation of airtime services .............................................................4-39
4.6.1 ID numbers for the AVIATOR 700S system ......................................4-39