Chapter 3: Operation
98-148232-E To access the terminal from a remote location 29
1: Wake up the terminal from power save.
24: Run the Terminal watchdog once a day (24 hours).
100.100.100.130: Primary IP address.
100.100.100.110: Secondary IP address.
200.247.237.254: Tertiary IP address.
0: Set the APN type to SIM default (0 = SIM default, 1 = Network assigned, 2 = User
defined).
NA: When the APN type is SIM default, the APN name is ignored.
CLR: The user name is cleared. When the default APN is used, any previous user name and
password should be cleared, unless a new manual user name is entered (NA would
maintain any previous setting).
CLR: The password is cleared. When the default APN is used, any previous user name and
password should be cleared, unless a new manual password is entered (NA would maintain
any previous setting).
NA: Position SMS response is not applicable (see note below).
NA: Number for position SMS response is not applicable (see note below).
Response:
You do not get an OK response. You can use the ADVWATCHDOG 1 command to get the
settings of the ADVWATCHDOG feature.
See also Terminal watchdog on page 37 and SMS remote command summary on page 127.
ADPWRST: Reset the administrator password
To reset the administrator password you need the IMEI number of your terminal. If you can
access the web interface, you can find the IMEI number under Support > About, see About
on page 76.
The text in the ADPWRST SMS must have the following format:
ADPWRST 1 <imei> <rsms_pwd>
Example: To reset the administrator password of a terminal with the IMEI number 363833-
09-012345, send an SMS with the text:
ADPWRST 1 36383309012345 remote
Response:
You receive a response with the result of the action.
Example: A response for a successful ADPWRST command, could be:
ADMIN RESET SUCCESS
SMS-Free: 88/100
WARNING: Ensure SMS-free > 5. Cleanup old msgs for
orderly Remote SMS Control
Position SMS response is for future use, and should be set to NA.
To Next Page
Loading...
