Chapter 4: Configuration with web interface
98-148232-E Advanced settings 84
7. Select Enable position SMS and enter the phone number, if you want the terminal to
send SMSes with the position of the terminal to a phone number. The SMSes will be sent
with the Watchdog interval from step 4.
8. Select Enable loopback SMS and enter the phone number of the terminal, if you want
the terminal to send SMSes to itself in order to check the SMS function. The SMSes will be
sent with the Watchdog interval from step 4.
9. Click Save.
Next run time: This field at the bottom of the page shows what time the Terminal watchdog
will run next (UTC time).
Data limits (BGAN only)
You can set a limit for the use of the BGAN data services with the EXPLORER 540 system.
If you have entered the call charges in the menu Call charges, the system automatically
calculates and displays the estimated maximum charges for your data sessions.
Once the entered limit is reached, the connection is automatically stopped. This is recorded in
the data log. To continue using the data service you must start a new connection by clicking on
the desired connection on the startup page.
To set data limits, do as follows:
1. Under Advanced, select Data limits.
2. Select the type of connection you want to limit.
3. Type in the amount of data or time allowed and select the appropriate units.
4. Select Enable.
5. Click Save to save the settings.
When the Watchdog is enabled, you must reboot the terminal before the
Watchdog settings are activated.
Thrane & Thrane A/S does not take responsibility for the correctness of the estimated
charges. This calculation is only a rough estimate of the charge, based on the tariff
entered by the user. Also, the airtime provider may have different methods of
calculating the charge.
If you have enabled automatic context activation of the Standard data connection
and you set a data limit for the Standard data connection, automatic context
activation is disabled.
To Next Page
Loading...
