Index
Block Up Converter Systems 6700/6900 series User Guide Index-3
redundancy controller
Auxiliary I/O interface 22, 51, 52
description 17
fault finding 107
fault monitoring 21
faults 101
LED indicators 18
mounting 42
power supply 21
switches 19
redundancy switching system
control 17
fault finding 100
operating 77
redundancy controller 17
remote controller 16
setting up 53
switching off 76
switching on 76
unpacking 28
relay contacts
Auxiliary I/O interface 51
remote controller 16
connecting 55
fault finding 109
Reset commands 74
reset command 74
reset latched faults command 74
reset to default values command 74
RF waveguide switch 42, 82
fault finding 101, 103
installing
receive 44
transmit 42
safety precautions 82
RS232 interface 37
RS422/485 interface 38
S
safety notices
radiation safety 123
safety precautions
fuse protection 83
overcurrent protection 83
RF waveguide switch 82
serial interface 37
BUC 50
commands 63
Help 64
Output 72
Reset 74
Set 65
View 73
connecting to the BUC 39
control during setup 39
FSK interface 38
monitor and control 62
RS232 interface 37
RS485 interface 38
servicing 82
Set commands 65
set burst mode power threshold command 68
set compensation frequency command 66
set echo command 71
set local oscillator command 69
set on line command 70
set packet address command 71
set packet protocol command 71
set redundant mode command 69
set serial interface command 70
set transmit attenuator command 67
set transmit default command 69
set transmit on command 65
set transmit power alarm threshold command
67
signal switching 17
stream switching 76
switch on
redundancy switching system 53
switches
redundancy controller 19
T
technical assistance 84
test procedures for fault finding 97
transmit frequency bands 7
U
unpacking
redundancy switching system 28
To Next Page
Loading...
Need help?
General
