CODEL EnergyTech 100 Series User Manual

CODEL
OPS. 141 29
Issue : A
Revision : 1
Date : 14/06/18
Doc i/d : 0118/6
050028
4.5.1.
Identification
From this option, the analyser type, its program number, and the device identity
of the instrument may be displayed.
• Instrument type - EnergyTech 100 Series 101/102
• EPROM number - will display the communications EPROM ID
• Identity - for factory set-up only
4.5.2.
Parameters
The following parameters are examined from this option, selected using the
ARROW keys :
• Measurement Path Length
The path length between the transmitter and receiver. This value is not used
within the current program and is for reference only.
• Dust Factor
A 'Dust Factor' is used to calculate the dust density; see section 5.12.
• Output Fault 1
Should a fault condition occur on output 1, the analogue output can be set from
one of four options see the set-up mode. The selected option may be examined
here.
• Output Fault 2
As above for output 2.
• Auto Zero
The auto zero facility compensates for any optical contamination.
Compensation ranges from 0.1% - 8% and can be displayed here. INHIBIT is
displayed if the option is not selected.

CODEL EnergyTech 100 Series Specifications

General

Brand	CODEL
Model	EnergyTech 100 Series
Category	Measuring Instruments
Language	English