EasyManuals Logo

CODEL EnergyTech 100 Series User Manual

Default Icon
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
CODEL
OPS. 141 36
Issue : A
Revision : 1
Date : 14/06/18
Doc i/d : 0141/6
050028
4.8.
Set-up Mode
All system parameters can be changed and a basic calibration initiated from this
mode. To prevent any unauthorised changes, the user must enter a four
number security code before the mode can be accessed.
! After this mode has been selected, the instrument will suspend
its operation. If no key is pressed within 5 seconds after
selection of this mode, the instrument will revert to the normal
operating mode.
Press the MODE key until the number 5 is displayed in the top left-hand corner.
After the security code has been correctly entered, there are 8 sub-modes of
operation, (see Figure ), from which the set-up parameters may be changed;
these are :
Set Averages
The four averaging stack times (seconds, minutes, hours & days) may be set as
required. The averages may also be reset from this menu.
Configure O/P 1
The first analogue output is configured from this sub mode.
Configure O/P 2
As above for analogue output 2.
Alarm 1
The source, units and level of the alarm for output 1 are set here.
Alarm 2
As above set for output 2.
Parameters
The following are set from this mode : security #, identity #, pathlength, dust
factor, auto zero and plant status.
Normalisation

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CODEL EnergyTech 100 Series and is the answer not in the manual?

CODEL EnergyTech 100 Series Specifications

General IconGeneral
BrandCODEL
ModelEnergyTech 100 Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals