CODEL EnergyTech 100 Series User Manual

CODEL
OPS. 141 5
Issue : A
Revision : 1
Date : 14/06/18
Doc i/d : 0141/6
050028
4.8.3. Configure O/P1 40
4.8.3.1. Output 41
4.8.3.2. Average 41
4.8.3.3. Units 41
4.8.3.4. Span 41
4.8.3.5. Fault Condition 42
4.8.3.6. Set mA Output 43
4.8.4. Configure O/P2 44
4.8.5. Alarm 1 44
4.8.5.1. Source 44
4.8.5.2. Units 45
4.8.5.3. Level 45
4.8.5.4. Exit 45
4.8.6. Alarm 2 45
4.8.7. Parameters 45
4.8.7.1. Security Number 46
4.8.7.2. Identity Number 46
4.8.7.3. Measurement Path Length 47
4.8.7.4. Dust Factor 47
4.8.7.5. Auto Zero 47
4.8.8. Normalisation 48
4.8.8.1. Setting the Normalising Parameters 50
4.8.8.2. Temperature 50
4.8.8.3. Oxygen 51
4.8.8.4. Pressure 51
4.8.8.5. Water Vapour 51
4.9. Calibrate 52
4.9.1. Set Detectors 52
4.9.2. Set Rx Gain 53
4.9.3. Calibrate 53
4.10. Calibration for Dust Measurement 54
4.10.1. Estimate of a Dust Factor 55
5. System Description 56
5.1. Transmitter 56
5.2. Receiver 56
5.3. Signal Processor Unit 56
5.4. Power Supply Unit 57

CODEL EnergyTech 100 Series Specifications

General

Brand	CODEL
Model	EnergyTech 100 Series
Category	Measuring Instruments
Language	English