Technical Manual Page 26 CODEL
OPS.080 Issue : C Rev. : Date : 16/7/08 Doc. i/d : 0080/6 Ref. : 080040
Set sensor selector to SCU. Insert address of SCU at Address selector (this will probably be 1).
Set sensor selector to GCEM 4000, set Function selector to 'Read'. Click on 'read data control' and ensure the
'message received indicator' turns green and that data is deposited in the 'Data access window', shown below,
where a binary stream should be visible in the data window. If not, try again, but if after several attempts nothing
happens, check for good communications between the pc and SCU.
Sensor
Selector
Address
Selector
Data
File
Selector
Function
Selection
Buttons
Comms.
Validity
Indicator
Transmit &
Receive
Indicators
Report
Generator
Auto Read
Stop/Start
Control
DATA WIONDOW
Read
Data
Control
DATA
ACCESS
WINDOW
To Next Page
Loading...