Technical Manual CODEL
OPS.080 Issue : C Rev. : Date : 16/7/08 Doc. i/d : 0080/6 Ref. : 080040
Contents
1. CODEL GCEM4000 Analyser – Introduction 1
1.1. Foreword 1
1.2. GCEM4000 Basic Principles 2
1.3. Emission Monitoring and the GCEM4000 3
1.3.1. Normalisation 3
1.3.2. Verification 3
1.4. User Interface 3
1.5. Analogue and Logic Inputs and Outputs 3
1.6. CDC Serial Port - for use with the CODEL SmartCEM system 4
1.7. Analyser Protection 4
2. Summary Specification 5
3. Preparing for Installation 7
3.1. Unpacking. 7
3.1.1. The Basic Analyser 7
3.1.2. Transceiver Weather Cover 8
3.2. Additional Materials 8
3.3. Ancillary/Additional Equipment 10
3.4. Services 10
4. Installation 11
4.1. Selection of Measurement Position 11
4.2. Analyser Positioning 12
4.3. Fitting of Stub-Pipes and Mounting Flanges 13
4.3.1. Metal Ducts/Stacks 14
4.3.2. Concrete and Brick Stacks 14
4.3.3. Double Skin Stacks 15
4.4. Installation of Purge Air Supply 15
4.5. Installation of Measurement Tube 15
4.6. Fitting the Active Weather Cover and Sensor Head 17
4.7. Installation of the GCU 22
4.8. Wiring Connections 22
4.8.1. Installation and Connection of Cables 22
4.9. Installation of Normalising Measurements (Oxygen, Temperature and Pressure) 22
4.10. System Connections 23
5. Commissioning 25
5.1. Pre-Commissioning Checks 25
5.2. Power On 25
5.3. Initial Set-Up Using SmartCOM Software 25
5.3.1. Adjust Alignment 27
5.3.2. Thermistor Control 28
5.3.3. Source Temperature Control 30
5.3.4. Cell Oven Control 31
5.3.5. Rx Temperature Check 31
To Next Page
Loading...
Need help?
General
