Technical Manual Page 58 CODEL
OPS.080 Issue : C Rev. : Date : 16/7/08 Doc. i/d : 0080/6 Ref. : 080040
Appendix 1 – Setting Analyser Gains
The need to reset gains after manufacture and testing is very rare, but if necessary, there are a number of
methods that depend on the analysers' configuration and its date of manufacture. Consult CODEL to check that
gain resetting is necessary and to obtain instructions for the appropriate method. The analysers' serial number
should be quoted at this time.
Gain setting requires access to the circuit boards within the receiver and should only be
undertaken by a trained instrument technician.
To Next Page
Loading...