Technical Manual Page 1 CODEL
OPS.080 Issue : C Rev. : Date : 16/7/08 Doc. i/d : 0080/6 Ref. : 080040
1. CODEL GCEM4000 Analyser – Introduction
Please take a few minutes to read this section before proceeding with installation. It is designed to
provide an overview of the analyser and its capabilities so that the information given later will be more
easily understood.
1.1. Foreword
SmartCEM is the ultimate solution for continuous monitoring of flue gas emissions. It is a fully integrated
monitoring concept from the basic analysers and their calibration verification packages through to digital
communications, data logging and automatic reporting.
At the heart of this concept is the SmartCEM station containing all the analysers and monitors to provide
comprehensive stack emission monitoring. The SmartCEM Station Control Unit (SCU) provides power to and
communicates with the analysers and monitors within that station.
Data from up to 32 SmartCEM stations is transmitted via a serial digital link (CODEL SmartBUS) to the Central
Datapoint where it is logged on a dedicated pc or assembled for onward transmission to a plant computer or
DCS. The arrangement of a typical SmartCEM system is illustrated in Figure 1.
Figure 1 : Typical SmartCEM System Arrangement
To Next Page
Loading...
Need help?
General
