e-mark create marking device Chapter 6 Maintenance
CODI Standard 1.0 52/60
Operating and Maintenance Manual
14. ALWAYS place in the docking station.
Fig. 50: Put into docking station
ALWAYS place the e-mark create in the docking station after use.
Otherwise, the ink cartridge head dries out, affecting print quality.
If the e-mark create is not placed in the docking station immediately:
- switched on: a warning signal sounds (return to docking station!)
- switched off: NO warning signal sounds
Tip: Always place the e-mark create in the docking station first and then switch it off.
Cleaning could make electrical components damp, causing injury to
people through electric shock.
During cleaning work, avoid any ingress of water, steam or cleaning agent in the
electrical components of the product.
Wipe down the product with a damp cloth.
All cleaning work on the product must be carried out by people who have read this Operating and Maintenance
Manual and who are informed of the hazards that can result from this product.
For cleaning purposes, the product can be vacuumed, brushed or wiped with a damp cloth that does not contain an
aggressive cleaning agent.
Regardless of general cleaning activities, the following cleaning operations must be performed at the stipulated
intervals:
Daily and/or after every time in use
Every week or as required
To Next Page
Loading...