e-mark create marking device Chapter 1 Introduction
CODI Standard 1.0 6/60
Operating and Maintenance Manual
1 INTRODUCTION
With the COLOP e-mark create marking device you have a product that is exemplary in terms of safety for users and
leading edge in terms of technology. In spite of this, the e-mark create may be hazardous if used incorrectly or not
as intended. We refer to potential hazards in Section 2 ‘Safety’ and with safety notices throughout the entire
documentation.
Preface
This original documentation is intended to assure safety-aware work on and with the product. It contains safety
notices that must be followed! Everybody who works with the e-mark create must have access to this documentation
and must observe the relevant specifications and instructions. The documentation must always be complete and
easily legible.
COLOP Digital GmbH is not liable for technical or printing-related defects in this documentation, nor will it accept any
liability for damage caused directly or indirectly by the delivery, performance or usage of this documentation.
Identification
The COLOP e-mark create is clearly identified on both the product and the packaging. Even if the illustrations in this
document correspond to the e-mark (an additional product within the COLOP product range) and not the e-mark
create, they are equally valid for the respective function as for the e-mark create.
CE mark in accordance with Directive 2014/35/EU (Low-Voltage Directive)
1.1 Legal details
COLOP Digital GmbH
Dr.-Arming-Straße 5
A-4600 Wels
Austria
Phone: +43 (0) 7242 661 04
Fax: +43 (0) 7242 466 64
E-Mail: emark@colop.com
Website: https://emark.colop.com/
To Next Page
Loading...