Colop e-mark create - Principle

e-mark create marking device Chapter 1 Introduction
CODI Standard 1.0 8/60
Operating and Maintenance Manual
Target groups and previous knowledge
Users of the e-mark create are non-professionals, aware of the hazards associated with using the device via the
safety pictograms on the e-mark create and instructions in the Quick Setup Guide and in this Operating and
Maintenance Manual. Users are able to recharge the e-mark create with the power adapter (supplied) and replace
ink cartridges. Users are not authorized to carry out repairs on the product.
Inspection and maintenance and/or repairs must only be carried out by qualified electricians.
The content and purpose of this documentation
Users can download this original Operating and Maintenance Manual at https://emark.colop.com/usermanual for
information.
This documentation contains the relevant information for e-mark create assembly, commissioning, operation,
maintenance and disposal. This documentation is intended to ensure hazard-free work with the e-mark create.
Compliance with the instructions contained within this document enables hazard-free working and avoids damaging
the e-mark create.
Limits of use
The limits of use for the e-mark create are defined as follows:
 The device is intended for use in enclosed, clean and dry areas (offices, warehouses, private residences)
 Horizontal place of use on level, firm ground
 Ambient temperature: +15 °C to +35 °C
 Humidity range 5 % to 100 % (storage 5 % to 80 %)
 The e-mark create is a marking device to print imprints sent via a software application
 It can print directly onto a variety of absorbent surfaces including standard paper, cardboard, fabric, wood,
cork, dry wall, high-gloss paper, photo paper and other surfaces with special coatings.
 The e-mark create is fitted with an LED light strip.
 The rechargeable battery of the e-mark create is recharged using the power plug.
1.4 Principle
This product incorporates state-of-the-art technology and complies with applicable health and safety regulations.
Nonetheless, the following hazards can arise as a result of incorrect transport, improper use, or failure to observe
the safety instructions contained in this Operating and Maintenance Manual or in the event of misuse:
 fatal or serious injury to users or third parties
 damage to the product and other items of capital equipment
 impairment to the efficient operation of the product