e-mark marking device Chapter 5 Operation
CODI Standard 1.0 Page 41 of 61
Operating and Maintenance Manual
Select a language and press “Next”.
Confirm the WIFI information by clicking on the box and click press “Continue”.
Fig. 33: Software wizard – Connection to e-mark
Connect the e-mark via the WIFI interface. Enter the SSID and password and press “Connect” to set up
the connection. The SSID and password can be found on the Quick Setup Guide in the packaging and
have been saved as a test imprint on the e-mark. SSID stands for "Service Set Identifier" and provides
information on the name of the WIFI network to your e-mark.
Press "Continue without e-mark connection" to continue without setting up the connection to the e-mark.
The e-mark can also be used without connecting to the App (previous initial use still required through the
App) or with a USB cable connection to a computer (see chapter 5.8).
Then press “Next”.
The e-mark is connected to your device via WIFI. A test imprint can now be made.
Then press “Next”.
To Next Page
Loading...
