Page 30 INSTALLATION & USER'S MANUAL CLITE2
SWITCH ON LIGHT 13.
This searchlight is equipped with two LED lamp modules.
As default both lamps will be turned on by pressing button (2) or (5), both lamps will be soft
started with a slight delay in between *
1
, no matter which button is used.
To turn off the light, press button (2) or (5) again.
There are however occasions when it may be useful to give each lamp a dedicated light button,
this setting is done in the "Single lamp mode" menu, please see 15.8.5.5 Single lamp mode.
In the bottom part of the display there are two sun-symbols that indicates the status of the LED-
lamps.
*1 The LED soft-start function is optimized to prevent a high inrush current during startup.
To Next Page
Loading...