InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
Do not enter your or other recipient's e-mail address. Recipient's addresses
are to be entered into the setpoints AcallCH1-Addr, AcallCH2-Addr and
AcallCH3-Addr.
NOTE:
Most of SMTP server will reject sending e-mails that contain nonexisting
address in the sender address field.
12.2.3.30 Setpoint: Time zone
This setpoint is used to select the time zone where the controller is located.
See your computer time zone setting (click on the time indicator located in
the rightmost position of the the windows task bar) if you are not sure about
your time zone.
NOTE:
If the time zone is not selected properly the active e-mails may contain
incorrect information about sending time, which may result in confusion when
the respective problem actually occured.
12.2.3.31 Setpoint: DNS IP
In fixed settings mode this setpoint is used to adjust the domain
name server (DNS), which is needed to traslate domain names in e-
mail addresses and server names into correct IP addresses.
In Automatic settings mode this setpoint is used to display DNS
server, which has been assigned by the DHCP server. It is not
possible to change the setpoint value manually in this setting (the
value is immediately reverted back by controller communication
module IB-COM).
To Next Page
Loading...
Need help?
General
