InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
See also the setpoint TimerChannel 6 and output TimerAct 5-8.
NOTE:
See the chapter Timers for more details about timers.
14.2.1.37 Binary input: Timer block 7
This input is used to disable temporarily the output from the Timer channel
#7.
NOTE:
See also the setpoint TimerChannel 7 and output TimerAct 5-8.
NOTE:
See the chapter Timers for more details about timers.
14.2.1.38 Binary input: Timer block 8
This input is used to disable temporarily the output from the Timer channel
#8.
NOTE:
See also the setpoint TimerChannel 8 and output TimerAct 5-8.
NOTE:
See the chapter Timers for more details about timers.
14.2.1.39 Binary input: Timer block 9
This input is used to disable temporarily the output from the Timer channel
#9.
NOTE:
See also the setpoint TimerChannel 9 and output TimerAct 9-12.
To Next Page
Loading...
Need help?
General
