ComAp InteliMains 210 BTB - Page 291

InteliMains 210 Global Guide
291
Setpoint group CM-Ethernet Related FW 2.0.0
Range [units] Valid IP address [-]
Default value 8.8.8.8 Alternative config NO
Step [-]
Comm object 24362 Related applications MCB, MGCB, BTB
Description
The setpoint is used to select the method how the DNS Address 1 is adjusted.
If IP Address Mode (page 289) is FIXED this setpoint is used to adjust the domain name server (DNS), which
is needed to translate domain names in email addresses and server names into correct IP addresses.
If IP Address Mode (page 289) is AUTOMATIC this setpoint is inactive. The DNS server IP address is
assigned by the DHCP server.
DNS IP Address 1
6 back to List of setpoints
Setpoint group CM-Ethernet Related FW 2.0.0
Range [units] Valid IP address [-]
Default value 8.8.8.8 Alternative config NO
Step [-]
Comm object 24331 Related applications MCB, MGCB, BTB
Description
The setpoint is used to select the method how the DNS Address 2 is adjusted.
If IP Address Mode (page 289) is FIXED this setpoint is used to adjust the domain name server (DNS), which
is needed to translate domain names in email addresses and server names into correct IP addresses.
If IP Address Mode (page 289) is AUTOMATIC this setpoint is inactive. The DNS server IP address is
assigned by the DHCP server.
DNS IP Address 2
6 back to List of setpoints
Setpoint group CM-Ethernet Related FW 2.0.0
Range [units] DISABLED / ENABLED [-]
Default value Disabled Alternative config NO
Step [-]
Comm object 24337 Related applications MCB, MGCB, BTB
Description
Enable or disable MODBUS communication via ethernet interface.
MODBUS Server
6 back to List of setpoints