Safety Information
10
C3M2-OM-EN-02
Warning
Every forklift operator must be trained in accordance with the rules provided
by the relevant local Health and Safety Authority (HSA).
Employers must ensure that each powered industrial truck operator is
competent to operate a powered industrial truck safely as demonstrated by
the successful completion of the relevant training as specified by the
relevant local authority. Operating a powered industrial truck without the
proper training can cause serious injury or death.
Horn
The horn allows the operator to alert anyone in the vicinity of the truck that it is
approaching. It can be used to request people to stay clear of the truck.
Reversing Alarm
The reversing alarm sounds when the truck begins to move in reverse. This is to
alert individuals in the presence of the truck that it is reversing.
Flashing Beacon
The flashing beacon is activated when the key switch is turned to the ON position to
alert individuals in the vicinity of the truck that it has been switched on.
The following optional warning devices may be fitted to the truck if required:
Forewarning Lights
Optional forewarning lights that illuminate when the truck begins to move in a certain
direction may be fitted if requested. The forewarning lights alert anyone in the trucks
path that it is approaching.
Motion Alarm
The motion alarm sounds when the truck begins to move in any direction. This is to
alert individuals in the vicinity of the truck that it is in motion.
1.6 Operator Qualification and Responsibilities
The operator of the Combilift must be qualified to operate the truck through
successful completion of a training program delivered by Combilift Driver
training personnel or a Combilift authorised training organisation.
Operators shall be aware of all local authority regulations and laws regarding
the qualification of material handling equipment operators.
No one shall operate the truck if impaired due to intoxication or drug reaction.
Always ensure that the truck is in good working order before commencing work.
This is achieved by performing the pre-use inspection. The inspection is to be
carried out at the beginning of the working day or at the start of each shift.
To Next Page
Loading...
