C4-C5XL MK3 O&S
4-9
C4000MK3-OM-EN-11
6) Remove the engine oil filter located on the back of the engine as
indicated in the diagram in the previous page. The filter is accessed by
lifting the bonnet as shown in the diagram.
7) Apply some engine oil to the new oil filter cartridge before fitting and
smear the o-ring seal with some oil.
8) Install the new engine oil filter cartridge, ensuring that the O-ring seal is
correctly placed. Only use a genuine Combilift component.
9) Reinstall the drain plug and tighten appropriately.
10) Fill the engine with the appropriate volume of oil ensuring that the oil
with the correct temperature range is used. The Volume of oil required
is:
a. Kubota Diesel Engine: 9.5 Litres / 2.5 US Gallons
b. GM LPG engine: 4.7Litres / 1.24 US Gallons
11) Check the oil level on the dipstick. Ensure that the oil level is at the
upper notch on the dipstick.
Note
Do not pour fluids into the ground, down a drain or into a stream, pond or
lake. Observe relevant environmental protection regulations when disposing
of oil, coolant, fuel, electrolyte and other harmful waste
To Next Page
Loading...
