CombiLift C7700 - Engine Oil and Engine Oil Filter (Service Interval = 250 Hours)

C4-C5XL MK3 O&S
4-8
C4000MK3-OM-EN-11
4.5: Engine Oil and Engine Oil Filter (Service Interval = 250Hours)
The engine oil used in the Combilift should have the correct temperature range
for the ambient temperature in which the machine is to be operating.
Temperature affects the viscosity of the oil and therefore it’s lubricating
properties. All Combilift trucks leave the factory with a special, high multi-grade
oil in the engine and this can be used all year round except in very cold
climates.
Recommended Engine Oil Specification:
Diesel: API – CF (See notes at 4.15: if diesel particulate filter is fitted)
SAE 15W40 – All Temperatures
SAE 10W30 – All Temperatures
LPG: API – SJ/CF
SAE 10W30 – All Temperatures
SAE 15W40 – Above -18°C (0°F)
In order to change the oil and oil filter, the following steps should be
taken:
1) If possible use an oil extractor to suck the used oil from the engine.
Follow the instructions supplied with the extractor. The dipstick is
located on the back of the engine as shown in the image below.
2) If an oil extractor is not available extend
the mast carriage forward in order to
gain access to the oil drain plug under
the engine.
3) Position a suitable container beneath
the Oil drain plug (see point 10 for the
volume of oil in the engine).
4) Remove the oil filler cap (on top of the
engine) and the drain plug and allow the
system time to drain completely
5) Once the system has drained
completely, dispose of the used oil in a
safe and responsible manner.
Dipstick
Oil Filter
Note
If a diesel particulate filter (DPF) is fitted to the truck then API CJ-4 engine oil
MUST be used.