C4-C5XL MK3 O&S
1-5
C4000MK3-OM-EN-11
Warning
Every forklift operator must be trained in accordance with the rules
provided by the relevant local Health and Safety Authority (HSA).
Employers must ensure that each powered industrial truck operator is
competent to operate a powered industrial truck safely, as demonstrated by
the successful completion of the relevant training as specified by the
relevant local authority. Operating a powered industrial truck without the
proper training can cause serious injury or death.
Personnel being trained, educated, instructed or participating in a general
training program may only work on or with the machine under constant
supervision of an experienced supervisor.
Work on the machine‘s electrical equipment may only be carried out by an
electrician or by trained persons under the direction and supervision of an
electrician.
Work on the chassis, brakes and steering system may only be performed by
trained, specialised personnel.
Only trained, specialised personnel with specific knowledge of and experience
in hydraulics may work on hydraulic units.
If the mast mechanism malfunctions or becomes stuck in a raised position,
operate the mast control lever to eliminate any slack in the chains. DO NOT
go under the elevated parts of the truck to attempt to carry out repairs.
1.6: Warning Decals
There are a number of different decals located around the Combilift. These
decals have different functions. Some indicate warnings - such as nip points
or moving parts, and some provide important information to the operator, such
as grease point locations. It is important to study what each one means and
where they are located
To Next Page
Loading...
