C4-C5XL MK3 O&S
4-10
C4000MK3-OM-EN-11
Note
Do not pour fluids into the ground, down a drain or into a stream, pond or
lake. Observe relevant local environmental protection regulations when
disposing of oil, coolant, fuel, electrolyte and other harmful waste.
Note
Cooling System Capacity = 16 Litres / 4.2 US Gallons
4.6: Engine Coolant
(Service Interval = 2000Hours)
CAUTION: Explosive release of fluids from pressurised
cooling system can cause serious burns. Shut off engine.
Only remove filler cap when cool enough to touch with bare
hands. Slowly loosen cap to relieve pressure before
removing completely.
All Combilift IC engine powered trucks leave the factory with a mixture of 50%
water to 50% coolant additive (
Glysantin
®
G64
®
from 02/2018)
in the cooling
system. This provides protection against corrosion and overheating and
prevents freezing down to -37°C (-34.6°F). If greater frost protection is
required, the coolant additive concentration can be increased up to 60% (frost
protection to -52°C (-61.6°F)). Any greater proportion of coolant will decrease
the frost protection and also the anti-corrosive properties.
The cooling system must be monitored regularly. This includes checking the
concentration of the antifreeze. The concentration of antifreeze to water must
never be allowed fall below 35% as the protective effects fall away rapidly
below this concentration.
Coolants must be completely replaced when repairs are performed on the
cooling system. Rinse out the cooling system before filling with new coolant. A
mixture of clean water with 15% of the new approved coolant is recommended
for rinsing.
Note
It is advised not to mix different coolant additives.
See www.combilift.com/coolant for a list of approved coolant products.
To Next Page
Loading...
