Bulletin 639536 • Revision L October 2014 19-1
Section 19
Device Test, Alarm Status, and Device
Information
The ATC Lite program allows users to obtain device information (includes hardware and software
version), get alarm status or clear alarms for any known device, or run a movement self-test on any
addressed device. These options are displayed as four buttons located in the Device Status and
Test section of the main screen (Figure 19-1).
Note: Get Alarms, Clear Alarms, and Self Test options are not available for any
SmartBeam antenna in AISG 1.1, AICM, AISM or SACM mode.
Figure 19-1. Device Status and Test Options.
.
.
To Next Page
Loading...
