ATC200-LITE-USB Teletilt
®
RET System Section 23–Changing the Operating Mode on a TMA
Bulletin 639536 • Revision L October 2014 23-3
8. When the operating mode of the TMA has been successfully completed, the Column Mode
will display the new mode (Figure 23-4).
Note. If a TMA is changes its operating mode to bypass mode, the current Gain provided
by device is zero. If a TMA is changed from bypass to normal (Amplifier On) mode the
current Gain shown is the stored value in the device.
Figure 23-4. Operating Mode changed for TMA
To Next Page
Loading...
