CommScope ATC200-LITE-USB - Part 4 - Operating Instructions for Standard Antennas with Attached Actuators; Section 5 Actuator Protocol Mode Switching; Section 6 Device Configuration; Section 7 Changing the Electrical Downtilt on a Single Antenna

To Next Page

To Previous Page

Table of Contents ATC200-LITE-USB Teletilt

RET System

ii October 2014 Bulletin 639536 • Revision L

vi October 2014 Bulletin 639536 • Revision L

Part 4 – Operating Instructions for Standard Antennas

with Attached Actuators

Section 5 Actuator Protocol Mode Switching....................................................5-1

5.0 Protocol Mode switching for ATM3 devices .............................................................. 5-1

5.0.1 Using AISG Reset Option Tools ............................................................................... 5-1

5.0.2 Switching a Single ATM200-002 to Ericsson Protocol .............................................. 5-4

5.1 Protocol Mode switching for AccuRET devices ........................................................ 5-6

Section 6 Device Configuration ........................................................................6-1

Section 7 Changing the Electrical Downtilt on a Single Antenna ......................7-1

Section 8 Changing the Electrical Downtilt on a Group of Antennas ................8-1

Part 5 – Operating Instructions for Antennas with Multiple

Integrated Actuators

Section 9 Switching Operating Modes for Multiple Integrated Actuators ........9-1

Section 10 Device Configuration for Antennas with Multiple Integrated

Actuators .....................................................................................10-1

Section 11 Adjusting the Electrical Downtilt on a Single Antenna Equipped

with Multiple Integrated Actuators ...............................................11-1

Section 12 Adjusting the Electrical Downtilt on a Group of Antennas Equipped

with Multiple Integrated Actuators ...............................................12-1

Part 6 – Operating Instructions for SmartBeam

Antennas

Section 13 Device Configuration with SmartBeam™ Antennas ......................13-1

Section 14 Changing the Electrical Downtilt on a Single SmartBeam™

Antenna ........................................................................................14-1

Section 15 Changing the Boresight (Pan) on a Single SmartBeam™

Antenna ........................................................................................15-1

Section 16 Changing the Beamwidth (Fan) on a Single SmartBeam

..................

Antenna ........................................................................................16-1

Section 17 Changing the Electrical Downtilt on a Group of SmartBeam™

Antennas .......................................................................................17-1

Other manuals for CommScope ATC200-LITE-USB