Compaq ProLiant 800 - Page 54

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-25
Compaq ProLiant 800 Server Reference Guide
Writer: Project: Server Management Comments:
File Name: D-ch2.doc Last Saved On: 4/23/97 11:14 AM
Compaq System Configuration Utility Pager Settings
for Booting into Compaq Utilities
continued
Pager Data Setting Description
Network
frame type
ETHERNET_I
I
Select the frame type for your network. Selections
include both Ethernet and Token Ring topologies.
Network IP
address
Enter the IP address for this server in standard dot
notation.
NOTE: This is not used if you select Custom for
Network controller. You must enter your IP address in
the NET.CFG file that you load into the system partition.
Network IP
net mask
Enter the net mask for this server in standard dot
notation.
NOTE: This is not used if you select Custom for network
controller. You must enter your IP address in the
NET.CFG file that you load into the system partition.
Network IP
router
address
Enter the router to be used for this server in standard
dot notation.
NOTE: This is not used if you select Custom for network
controller. You must enter your IP address in the
NET.CFG file that you load into the system partition.
If you configure the server to boot into Compaq Utilities, the server prepares
for remote communications, so you can remotely run Diagnostics software,
Inspect Utility, or System Configuration Utility using a workstation running
terminal emulation software, such as Compaq Insight Manager or PC
Anywhere.