. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-26 Server Management
Writer: Project: Server Management Comments:
File Name: D-ch2.doc Last Saved On: 4/23/97 11:14 AM
Booting into the Operating System
When you enable ASR-2 to restart into the operating system and a critical
error occurs, ASR-2 logs the error in the Critical Error Log and restarts the
server. The system ROM pages the designated administrator, and executes the
normal restart process.
IMPORTANT:
When you enable ASR-2 to restart into the operating system, Modem Dial-In
Status, Network Status, and Modem Dial-Out Status are automatically disabled. In this mode,
ASR-2 can page you if a critical error occurs, but you cannot access the server, and the server
cannot dial out to a remote workstation.
During the recovery process, the ASR-2 feature tries to restart the server up to
10 times. If the ASR-2 feature cannot restart the server within 10 attempts, it
logs a critical error in the Critical Error Log, restarts the server into the
Compaq Utilities, and puts the modem into auto-answer mode.
Your System Configuration Utility setting should resemble the following
when you enable ASR to restart into the operating system:
Serial interface COM1
Dial-in status Disabled
Dial-out status Disabled
Dial-out string 555-1234
Network status Disabled
Network protocol IPX
Network controller Compaq
Network host name CPQHOU
Network card slot Slot #
Network frame type ETHERNET_II
To Next Page
Loading...
