EasyManua.ls Logo

Condair EL2 - Inspections During Operation; 6.4 Carrying out Manual Draining; 6.5 Taking the Unit out of Operation

Condair EL2
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
48
6.3.3 Inspections during operation
DuringoperationtheCondairEL2andthehumidicationsystemhavetobeinspectedweekly.On
thisoccasioncheckthefollowing:
• thewaterandsteaminstallationforanyleakage.
• thesteamhumidierandtheothersystemcomponentsforcorrectxingandanydamage.
• theelectricinstallationforanydamage.
Iftheinspectionrevealsanyirregularities(e.g.leakage,errorindication)oranydamagedcompo-
nentstaketheCondairEL2outofoperationasdescribedinchapter6.5. Then, contact your Condair
representative.
6.5 Taking the unit out of operation
Inordertotakethesteamhumidieroutofoperation,performthefollowingsteps:
1. Iftheunithastobeswitchedoffbecauseofamalfunction,pleasenotetheerrorcode(number
ofashesoftheredandyellowLED)oftheactualerrormessageshowninthedisplay.
2. Closetheshut-offvalveinthewatersupplyline.
3. Start manual draining (see chapter 6.4)andwaituntilthesteamcylinderisempty.
4. Actuate the unit switch.
5. Disconnectsteamhumidierfromthemains:Switchoffallserviceswitchestomainssup-
plies(heatingandcontrolvoltage)andsecureswitchesin“off”positionagainstaccidentallybeing
switched on, or clearly mark the switches.
6. Ifambient temperatures ≤0°Cmustbeexpectedwhentheunitisoutofoperation (operation
oftheCondairEL2inaprotectivehousingoutsidethebuilding):drainthewatersupplypipeand
thewaterlter(ltervalve).
WARNING! Danger of burning!
Ifsteamwasproducedjustbeforetheunitistakenoutofoperation,waitbeforeopeningtheunit
andletthesteamcylindercooldowntopreventdangerofburning.
6.4 Carrying out manual draining
1. Brieypressthedrain/infokey. The heating voltage is interrupted and the
drain valve opens. The yellowLEDashes.
Note:thedrainvalveclosesafter10minutesautomatically
2. To stop the drain cycle brieypressthedrain/infokeyagain.
Proceedasfollowstodraintheunitmanually:

Table of Contents

Related product manuals