How to do it correctly
User manual 184
► Grill version (only for table-top appliances)
Restrictions on use
The following restrictions on use must be observed:
When the plug in the fat drain outlet is unscrewed, it is not permitted to operate the appliance as fol-
lows:
Without a fixed connection to the fat drain outlet
With the fluid running off into an open container beneath the appliance
Without an initial amount of fluid in the fat collecting container
Requirements
Check that the following requirements have been met:
You are already conversant with the operating steps listed under "How to do it correctly".
Preparing the grill version
Follow the steps below to prepare the grill version:
Step Action Illustration
1 Fill the fat collecting container with about 5 cm of water so that
the tube mouth lies under the surface of the water. Make sure
that the fat can drain freely into the fat collecting container.
Caution:
It is essential that the fat collecting container always contains
water (above the level of the tube mouth). Otherwise the
closed system inside the oven is unable to work.
2
Unscrew the plug from the drain outlet in the appliance base.
3
Slide the fat collecting tray into the appliance.
Caution:
The drain from the fat collecting tray must lie over the center of
the fat drain outlet in the oven floor.
4
The grill version is now ready for use.
5 When grilling, use the intermediate plates to prevent the
seasoning being washed off by dripping fat.
To Next Page
Loading...
