Convotherm OES - Including a Beep Signal in a Cooking Program

How to operate the control panel
User manual 87
► Including a beep signal in a cooking program
Objective
To be reminded to perform an action, such as adding liquid, at the end of a cooking program, you can
include a beep signal in the recipe.
After the beep sounds, you can then open the oven door and perform the required action. When you
re-close the oven door, the recipe continues with the next cooking step.
Requirements
To do this, the following requirements must be satisfied:
 You are in the process of entering a multi-step cooking program.
 You are in the Functions menu.
Including a beep signal in a cooking program
Follow the steps below to include a beep signal:
Step Action Button
1 Use the tilt selector switch to choose the "beep signal" icon.
2 Press the "Functions menu" button to confirm.
Result:
The Confirm menu appears in the display.
3 Use the tilt selector switch to choose "YES".
YES
4 Press the "Functions menu" button to confirm.
5 Continue entering the cooking program.
Result:
The beep signal sounds for 3 minutes after the end of a recipe
step. The recipe continues to run while it sounds.
Final step for saving the extra function of the beep signal
Depending on where you started from, you will need to use different buttons to complete the input
procedure and save the extra function for the beep signal:
Objective Button
To save the input in the temporary memory
To save the input as part of a recipe you are creating